Laser Yanke da Zane Inji Manual Mai Saurin Aiki

Mataki na 1: Haɗa na'urar sanyaya ruwa da famfon iska, kuma kunna wutar injin.

  

Mataki na 2: Yi amfani da sashin kulawa don nuna haske kuma duba idan hanyar hasken injin yana tsakiyar ruwan tabarau.(Lura: Kafin bututun Laser ya fito da haske, tabbatar da cewa mai sanyaya ruwa yana kiyaye yanayin sanyaya ruwa)

Mataki na 3: Haɗa kebul ɗin bayanai tsakanin kwamfuta da injin, karanta bayanan allo.

1) Lokacin da kebul na bayanai shine kebul na bayanai na USB.

2) Lokacin da kebul na bayanai shine kebul na cibiyar sadarwa.Dole ne a canza adireshin IP4 na tashar tashar kebul na kwamfuta da allon zuwa: 192.168.1.100.

Mataki na 4: Buɗe software na sarrafawa RDWorksV8, sannan fara gyara fayiloli da saita sigogin sarrafawa, sannan a ƙarshe loda shirin sarrafawa cikin allon sarrafawa.

Mataki na 5: Yi amfani da toshe tsayin tsayin daka don daidaita tsayin mai da hankali, (saka toshe tsayin tsayin daka akan saman kayan, sannan a saki ganga ruwan tabarau na Laser, bari ya faɗi akan tsayin mai da hankali ta dabi'a, sannan ƙara ƙarar ganga ruwan tabarau, kuma an kammala daidaitaccen tsayin dakafi)

Mataki na 6: Matsar da Laser kai zuwa wurin farawa na sarrafa kayan, (Asalin-Shigar-Fara-Dakata) kuma danna don fara sarrafawa.

Idan na'urar tana da axis Z tare da tebur mai ɗagawa, kuma an shigar da na'urar mai da hankali ta atomatik, da fatan za a sanya kayan da za'a sarrafa a ƙarƙashin mai da hankali ta atomatik, sannan danna aikin mai da hankali kan atomatik, kuma injin na iya buƙata ta atomatik. tsayin mai da hankali.