CNC Router machine maintenance and use matters needing attention

Advertising cnc router is through the computer design and type setting information transmission to the controller, and then the information into a stepper motor or servo motor with power signal (pulse string), control engraving machine host generation X, Y, Z three axis carving knife roadbed diameter.

No matter how good the quality of cnc router woodworking machine is, it will often fail without maintenance and maintenance for a long time. If you want to really make the equipment in the long-term processing, you not only require the quality of our equipment to be excellent, but also require us to regularly maintain and maintain the equipment.

1. Before starting the equipment, first check whether the line is intact and the voltage is stable. After checking, turn on the power supply of the machine and operate the machine for a period of time before starting processing.

2. Cnc router wood carving machine spindle has two kinds, one is air cooled spindle, one is water cooled spindle, water cooled spindle needs to keep the cooling water clean and the normal work of the pump, here is a clear reminder: water cooled spindle motor do not appear water shortage phenomenon. In addition to the above maintenance work, we should pay attention to the water temperature. Too high temperature of cooling water will greatly reduce the cooling effect and cause certain damage to the spindle, so we should replace the cooling water in time. In winter, anti-freezing measures should be taken to prevent water pipes from being frozen and cracked.

3. Clean the heat dissipation and ventilation system of the cnc router for wood electromechanical road box regularly, check whether the fans work normally, clean the dust in the electric control box regularly, and check whether the screws of the wiring terminals are loose to ensure the safe and reliable use of the circuit.

4. Clean the guide rail and surrounding sawdust in time, and oil the transmission system of the equipment in time.

5. Clean up dust, powder and oil stains on the sensor in time.

6. After the woodworking engraving machine is processed, take down the carving knife first and let the spindle chuck relax. This is helpful to extend the service life of spindle chuck. Then we began to clean the work surface, brush cleaning; Pay attention to the work surface is usually best not to accumulate sundries, lest the platform deformation. Finally, the nose should be moved to the lower left or lower right position to prevent collision, and then cut off the power supply.

7. If you do not use 1325 cnc router with rotary for a long time, it is best to electrify the air once a week to prevent the machine from being damp and ensure the stable and reliable performance of the electrical components of the equipment.

8. It is best not to open the cabinet often. There will be dust, wood chips or metal powder in the air when carving.

9. Check regularly whether the screws of all parts of the woodworking engraving machine are loose.

10. Vacuum pump maintenance:

The metal screen in the suction mouth of the water circulation air pump is used to prevent dust from entering. The screen should be kept clean at any time to avoid blockage and the pump pumping speed drop. When the pump is not used, it should be powered for a few minutes every week to prevent the pump body rust from normal operation.

Tongyou vacuum pump should also loosen the butterfly nut, take out the paper filter element and clean the filter mesh regularly with high pressure gas. If the filter element is found to be airless or damaged, it should be replaced in time. According to the length of use, high pressure oil gun can be used to oil the bearings of each part.

Do a good job of daily maintenance and maintenance in order to better prolong the service life of engraving machine, but also to improve the efficiency of engraving machine oh, so the majority of users in daily use must pay attention to raise.