Ukusika iLaser kunye noMkroli weManuwali wokuSebenza ngokukhawuleza

Inyathelo le-1: Qhagamshela i-cooler yamanzi kunye nempompo yomoya, kwaye uvule amandla omatshini.

  

Inyathelo lesi-2: Sebenzisa iphaneli yokulawula ukubonisa ukukhanya kwaye ukhangele ukuba indlela yokukhanya yomatshini iphakathi kwelensi.(Qaphela: Phambi kokuba ityhubhu yelaser ikhuphe ukukhanya, qiniseka ukuba isixhobo sokupholisa amanzi sigcina umjikelo wokupholisa amanzi)

Isinyathelo sesi-3: Xhuma ikhebula ledatha phakathi kwekhompyutheni kunye nomatshini, funda ulwazi lwebhodi.

1) Xa intambo yedatha yintambo yedatha ye-USB.

2) Xa intambo yedatha yintambo yenethiwekhi.Kuyimfuneko ukuguqula idilesi ye-IP4 ye-network cable port yekhompyutheni kunye nebhodi: 192.168.1.100.

Isinyathelo sesi-4: Vula i-software yokulawula i-RDWorksV8, emva koko uqale ukuhlela iifayile kwaye usete iiparitha zokucubungula, kwaye ekugqibeleni ulayishe inkqubo yokucwangcisa kwibhodi yokulawula.

Inyathelo lesi-5: Sebenzisa ibhloko yobude obugxininisiweyo ukulungisa ubude bokugxininiswa, (beka ibhloko yobude obugxininise kumphezulu wezinto eziphathekayo, emva koko ukhulule umgqomo welensi yentloko ye-laser, uyiyeke iwele kubude obugxile ngokwendalo, emva koko uqinise umgqomo welensi, kwaye ubude bojoliso obusemgangathweni bugqityiwe)

Inyathelo lesi-6: Hambisa intloko ye-laser kwindawo yokuqala yokulungiswa kwezinto, (Imvelaphi-Ngena-Qala-Qala-Pause) kwaye nqakraza ukuze uqale ukucubungula.

Ukuba umatshini une-Z-axis enetafile yokuphakamisa, kunye nesixhobo sokugxila ngokuzenzekelayo, nceda ubeke izinto eziza kucutshungulwa phantsi kwe-auto-focus, kwaye emva koko ucofe umsebenzi wokugxila ngokuzenzekelayo, kwaye umatshini unokufuna ngokuzenzekelayo. ubude bojoliso.